Kalorik TKG CM 1045 Manual Del Usuario página 5

Fax +32 2 359 95 50

If the water in your region is hard, descale your coffee maker every 7 to 10 uses as follows:
• Pour 3 cups of clean vinegar into the water tank and fill to the maximum level with water.
• Place the carafe on the warming plate.
• Plug in the coffee maker and press the on-off switch.
• When the water tank has emptied, switch off the coffee maker and empty the carafe.
• Rinse the coffee maker two or three times by repeating the above process using cold
water only.
PRACTICAL HINTS
When you notice that the coffee making process is longer than it should be, it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The decalcifying
frequency depends on the amount of lime in the water and therefore can be different from
family to family. Therefore it is important to pay attention to this. A good maintenance of your
appliance will prolong its lifespan. Guarantee claims will not be accepted for the replacement
of a heating element full of scale.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2012/19/EU
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
The user manual is by simple request also available in electronic format from the after-sales
service (see warranty card).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
5
Assembly page 5/37
on the
TKG CM1045- 170830