Connecting To An Antenna; Plug & Play (Initial Setup) - Samsung 4 Serie Manual Del Usuario

When the TV is initially powered on, basic settings proceed automatically.
✎
Preset: Connecting the mains and antenna.
TV Rear Panel
✎
The position of power input port
may differ depending on the model.
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the
POWERP button. Plug & Play is available only when the Input source is set to TV.
✎
To return to the previous step, press the Red button.
1
Selecting a language
2
Selecting Store Demo
or Home Use
3
Setting the Clock Mode
4
Time Zone
5
Selecting an antenna
6
Selecting a channel
7
Enjoy your TV.
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0". If you want to
change the PIN number, use the Change PIN function.
You should do Plug & Play (MENU
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets
the PIN to "0-0-0-0": MUTE

Connecting to an Antenna

Plug & Play (Initial Setup)
Press the ▲ or ▼ button, then press the ENTERE button.
Select the desired OSD (On Screen Display) language.
Press the ◄ or ► button, then press the ENTERE button.
Select the Home Use mode. Store Demo mode is for retail
environments.
To return the unit's settings from Store Demo to Home Use (standard):
Press the volume button on the TV. When the OSD volume is displayed,
press and hold MENU for 5 sec.
Store Demo is only for shop display. If you select it, several functions
are not able to use. Please select Home Use when you watch at home.
Set the Clock Mode automatically or manually.
Press the ▲ or ▼ button to select the your time zone, then press the ENTERE button.
(depending on the country)
Press the ▲ or ▼ button, then press the ENTERE button.
Select the desired broadcasting signal.
Press the ▲ or ▼ button, then press the ENTERE button.
Select the channel source to memorise. When setting the antenna source to Cable, a step
appears allowing you to assign numerical values (channel frequencies) to the channels. For
more information, refer to Channel → Auto Tuning.
✎
Some channel may not be transmitted to this television. It depends on Broadcasting
signal gain or specification.
✎
Press the ENTERE button at any time to interrupt the memorisation process.
Press the ENTERE button.
→ System) again at home although you did in shop.
→ 8 → 2 → 4 →
POWER (on).
English - 5
VHF/UHF Antenna
Cable
or
POWER
P