Filling The Magazine; Eu Declaration Of Conformity - BEA T54-155C Instrucciones Adicionales De Uso Específicas

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Pull pusher 1 backwards and engage. Insert staple rod into the
•
magazine from above and push forward. Disengage the
pusher and push it forward.
5

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
T54-155C
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13