Water Softener; Water Hardness - Telstar TLP060310MD Manual De Instrucciones

WATER SOFTENER

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of
the water used. This is intended to optimise and customise the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1.
Switch on the appliance;
2.
Press the Start/Pause button for more than 5 seconds to start the water softener set model within 60 sec-
onds after the appliance was switched on;
3.
Press the Start/Pause button to select the proper set according to your local environment, the sets will
change in the following sequence: H1->H2->H3->H4->H5->H6;
4.
Press the Start/Pause button to end the set up model.
ºdH GERMAN ºfH FRENCH
0-5 0-9
6 - 11 10 - 20
12 - 17 21 - 30
18 - 22 31 - 40
23 - 34 41 - 60
35 - 55 61 - 98
1°dH=1.25°Clarke=1.78 °fH=0.178mmol/l
The manufactory setting: H3
Contact your local water board for information on the hardness of your water supply.

WATER HARDNESS

ºClarke Británico
0-6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
Water softener
level
Mmol
0-0.94 H1
1.0 - 2.0 H2
2.1 - 3.0 H3
3.1 - 4.0 H4
4.1 - 6.0 H5
6.1 - 9.8 H6
20
DISHWASHER
TLP060310MD
Salt consump-
tion
(gram/cycle)
0
9
12
20
30
60