IXS xult Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
EN
WARNING
No helmet can protect against all possible impacts or injuries. The function of this helmet is to reduce the chance or severity of a head injury
in an accident. The helmet will not protect any area which is not covered by the helmet including the neck or spine. Serious injury or death
can occur even if the helmet is properly used. To ensure maximum protection, the helmet must fit properly with retention straps securely
fastened under the chin. See (FIG. B) for proper positioning and (FIG. E-G) for strap fastening instructions. The Xult helmet should not be
used by children while climbing or doing other activities when there is a risk of the child hanging him/herself. This helmet is designed for
cyclists and for users of skateboards or roller skates. This Helmet is not intended for use with motorized vehicles including motorcycles,
ATV's or motor scooters. Modifications or changes which do not correspond with the original product can result in severe injury or death. Do
not modify or remove any original components of the helmet unless replacing with approved iXS parts. Helmets should not be adapted for
the purpose of fitting accessories in any way not recommended by the manufacturer. This helmet has been designed to absorb impacts by
partial destruction of its components. After a violent impact, this helmet should be discarded and replaced even if it looks undamaged. Always
check your helmet before use. If there is visible damage, stop using the helmet immediately. If you find deterioration in any component, either
replace that component or get a new helmet. Check the security of the retention straps and always make sure that the interior lining and the
cheek pads are attached before use.
SIZING
To be effective, the helmet must fit properly. Refer to the helmet's size range and try on different sizes to deter-
mine which size feels most secure and comfortable.
To determine your helmet size:
• Wrap a tape measure around the head horizontally about 2.5cm or about 1 inch above the eyebrows to obtain
the largest head circumference measurement. See (FIG. A)
• Use the size chart to select a helmet which is closest to your head size.
• Note that the size chart is intended to be used as a guide and not a substitute for trying the helmet on.
HELMET SUGGESTED SIZE CHART (ADULT)
SIZE
POSITIONING
HEAD CIRCUMFERENCE
S/M
M/L
53-56cm
57-59cm
6
L/XL
60-62cm
FIG. A

Publicidad

Tabla de contenido
loading

Productos relacionados para IXS xult

Tabla de contenido