Eye Protection - IXS xult Manual Del Usuario

EN

EYE PROTECTION

All iXS helmets are designed for use with eye protection. The Xult helmet has been
specifically designed for use with goggles. See (FIG. H) for proper goggle fit. It is your
responsibility to obtain and use eye protection.
EPR (EMERGENCY PADDING RELEASE)
WARNING
• The following illustrates the functionality of the Xult EPR system, but should not necessarily be
implemented for all types of injuries and conditions. Consult medical or emergency staff before
removing the helmet of an injured person.
• Xult cheek pads are secured to the helmet using Hook and Loop Velcro fasteners which can be
removed by pulling on the release tabs located on the bottom of the cheek pads away from the
helmet as shown in (FIG. I)
• Reverse order for reinstalling cheek pads
COMFORT INTERIOR LINING REMOVAL/INSTALLATION
The Comfort Interior Lining is attached to the helmet EPS via snap
buttons and tabs at the front and rear of the helmet and may be
removed for cleaning or replacement.
To Remove:
• Gently pull on the liner at the back corners until left and right
rear snaps disengage
• Repeat this process for the front snap located at the center brim
To Install:
• Slide the front and rear side tabs of the liner between the shell
and EPS
• Align Center and rear snaps to their corresponding fixtures on
the EPS and press firmly until engaged
• Make sure the liner fits securely underneath the Eye-port Lining
and rear EPS protector.
8
FIG. H
FIG. I