Recording - Panasonic SC-AKX710 Instrucciones De Funcionamiento

█ Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNE MODE".
2
Press [Y, U] to select "PRESET" and then press
[OK].
3
Press the numeric buttons, [2/3] or
[5/6] to select the preset station.
Improving the sound quality
When "FM" is selected
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [Y, U] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also cancelled when you change the
frequency.
To memorise the setting
Continue with step 4 of "Manual presetting"
( 10).
When "AM" is selected
1
Press [PLAY MENU] repeatedly to select
"B.PROOF".
2
Press [Y, U] to select the setting that provides the
best reception and then press [OK].
Checking the signal status
When "FM" is selected
Press [DISPLAY] to select "FM STATUS".
FM – – – – The FM signal is weak.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the "FM MODE".
The FM signal is in monaural.
RDS broadcasting
This system can show the text data transmitted by the
radio data system (RDS) available in some areas.
Press [DISPLAY] repeatedly.
PS Programme service
PTY Programme type
FREQ Frequency
Note:
RDS may not be available if reception is poor.
AM allocation setting
By main unit only
This system can also receive AM broadcasts allocated in
10 kHz steps.
1
Press [SELECT] repeatedly to select "AM".
2
Press and hold [SELECT].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.

Recording

This system can record up to 800 folders (maximum 999
tracks in an album) or a total of 8000 tracks, depending on
the available storage capacity of the internal memory or
the USB device in .
USB B
To check storage space
In the stop mode, press [DISPLAY] repeatedly.
Example: Remaining recording time of the internal
memory.
Internal memory
source
• "UPDATE" is shown when the system is reading the
USB device.
• "NO DEVICE" is shown if there is no USB device
connected to .
USB B
To select where recordings are kept
1
Press [SETUP] repeatedly to select "REC TO?".
2
Press [Y, U] to select "MEMORY" or "USB B" and
then press [OK].
Note:
•
All recordings are in ".mp3" format.
•
You cannot do recording when you are using random
playback mode.
•
The DJ function or Karaoke function is switched off when
you start recording.
•
Repeat playback mode is cancelled during recording.
•
A new album is added each time you do a recording.
•
The sequence of album may change after the recording.
•
The recordings are kept in a folder named "REC_DATA" in
the USB device or the internal memory.
•
USB status indicator blinks in red during USB recording.
Remaining
recording time
11
11