Technical Data - Beta 1498/30A Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
BATTERY CHARGER SAFETY
• Periodically check the battery charger, the power supply cable and the clamps.
• Do not use the battery charger when damaged, to avoid the risk of electric shocks; do not try to open
or modify it.
• Connect the battery charger to the mains socket, making sure that the mains voltage matches that stated on
the power supply device. (See TECHNICAL DATA table)
• Do not cover the battery charger when using it. Allow adequate space for ventilation.
• Do not use the battery charger in humid or wet environments; do not expose it to rain. Wet and contaminated
environments increase the risk of electric shocks.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING BATTERY CHARGER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING BATTERY CHARGER
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
RATED VOLTAGE
CHARGING VOLTAGE
ABSORBED POWER
BATTERY CHARGING CAPACITY
BATTERY HOLDING CAPACITY
CLAMP CABLE LENGTH
CLIP CABLE SECTION
POWER SUPPLY CABLE LENGTH
DEGREE OF PROTECTION
DIMENSIONS
WEIGHT
6V-12V-24V Wet - Agm - Lithium LiFePO4
220V ÷ 240V 50/60Hz
6V - 12V - 24V
450 W
5 ÷ 300 Ah
5 ÷ 600 Ah
2.5 m
10 mm2
1.3 m
IP20
270x330x130 mm
4.2 kg
EN I
13