Publicidad
Idiomas disponibles
Idiomas disponibles
No change in measurements if connected with
drain illustrated.
(K-7161-AF or K-7161M-AF)
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
42" (106.7 cm)
Product Information
Applicable product:
Drop-in bath with airjets
Fixture*:
Bathing well:
Basin area
48" (121.9 cm) x 27" (68.6 cm)
Top area
60" (152.4 cm) x 30" (76.2 cm)
Weight
150 lbs (68 kg)
To overflow:
Water depth
16" (40.6 cm)
Capacity
94 gal (355.8 L)
* Approximate measurements for comparison only.
Drop-in cut-out
70-1/2" (179.1 cm) x 40-1/2" (102.9 cm)
Blower motor/control:
1035474-1-E
11-3/4"
(29.8 cm)
22"
(55.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
K-1418-G
Heater
V
Hz
300 W
220-240
50/60
36" (91.4 cm)
1-1/16" (2.7 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control:
Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 35 lbs
(168 kg) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
This bath is designed for drop-in installation only. It is not suited
for use in a three-wall alcove with an overhead shower.
A blower motor/control access panel is required.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
A
3
2
K-1418-G
5-1/4" (13.3 cm)
72" (182.9 cm)
3" (7.6 cm)
1-1/2" OD
220-240 V, 15 A, 50/60 Hz
1-7/8"
(4.8 cm)
20-1/8"
(51.1 cm)
Kohler Co.
Publicidad
