Publicidad
Idiomas disponibles
Idiomas disponibles
Plate mount
Step A: Remove the mounting clamp assembly from the clamp bracket on the base.
Step B: Remove the clamp bracket from the base. Keep the screws you remove. You will use
them later.
Step C: Make sure that the side of the grommet bracket with recessed screw holes is facing
up. Insert the M8 × 95 mm screw through the square hole in the center of the grommet
bracket.
Note: To keep the M8 screw from falling inside the base, temporarily attach the wing nut to
hold in place.
4 mm
4 mm
7
Publicidad
