vitapur Pro Soft VWS296GR Manual De Uso página 12

The ONLY Parameters Set By Consumer (or plumber):
a) Language
b) Set Clock
c) Under Advanced Setting
i) Set the regeneration time" Recharge Time"
ii) Capacity under "Residual Water".
iii) Salt Setting Low, Medium and High Salt Setting
CAUTION: DO NOT CHANGE ANY OTHER PARAMETERS BEYOND THE 5 LISTED
ABOVE. IT WILL ADVERSELY AFFECT THE PERFORMANCE OF THE WATER SOFTENER
The programming for the water softener is set-up with the default settings listed in the table below.
The ONLY parameters that should be accessed by plumber/consumer are shown in the table as "Adjust".
Main Menu Display
Set 12/24 Hour Clock
Set Clock
Water Used Today
Average Water Use in Week
Set GAL/L/Cubic Meters
Advance Settings
Sub Menu Advanced Settings Display
Set Work Mode
Set Recharge Time (Regeneration Time)
Set Residual Water (Capacity)
Set Interval Wash
Set Back Wash
Set Brine & Rinse
Set Brine Refill
Set Fast Rinse
Set Max Days/Recharge
Set Output Signal
Set The Language: The default setting for the language is English. If you do not want to change
1.
the language proceed to set the clock. There are 7 languages to choose from consisting of French,
Chinese, Spanish, German, Italian, English and Russian.
Step 1. To change the language from English to any of the other 6 languages press the Menu/Confirm
and Manual/Return key
adapter.
Step 2. Scroll down to the language preference using the down arrow
Step 3. Press the menu/confirm key
Set The Clock: The time of day only needs to be set up during initial set up and after extended power
2.
outage (3 days). The battery back-up lasts up to 72 hours after a power outage. The default setting
on the clock is 12.00 a.m.
Step 1. Unlock program by pressing the down and up
if the screen is locked. If not locked proceed to Step 2.
Step 2. Press the Menu/Confirm Key
Step 3. The Clock Setting is the second item on the main menu.
Step 4. Press the Menu/Confirm Key
Step 5. Use the down or up arrows
as hours advance from morning to afternoon.
Step 6. Press the Menu/Confirm Key
arrows
Step 7. Press Menu/Confirm Key
Step 8. Press Manual/Return Key
parameters are going to be changed. If continuing to change other parameters scroll to desired
parameter using the down arrow
Display Screen.
Default Settings
12 hour clock
12:00 A.M.
Display on Daily Water Consumption
Display On Average Weekly Water Consumption
GAL
To Get Into Advanced Settings-Sub Menu
A-11
2:00 A.M.
1306 U.S. Gallons @ 20 grains/U.S. Gallon
F00
2 min
50 min
2 min
6 minutes
14 days
b-01
simultaneously within 2 seconds of plugging in the power
once to enter the main menu
and the hour in the clock setting will start flashing.
to scroll to the correct hour. The AM and PM will change
and the minutes will start flashing. Use the down and up
to adjust to the correct minute setting.
and menu will return to "Set Clock" in the main menu.
to proceed back to the In Service Display screen if no other
10
Access To Parameters
Not Adjustable
Adjust
Display
Display
Not Adjustable
Not Adjustable
Adjust
Adjust
Not Adjustable
Not Adjustable
Adjust only if salt setting is being changed
Adjust only if salt setting is being changed
Not Adjustable
Not Adjustable
Not Adjustable
arrows together and hold for 5 seconds
in the main menu without going back to the In Service