Selecting The Direction Of Rotation; Starting + Stopping; Battery Compartment - sunjoe 24V-DD-LTE Manual De Instrucciones

5. To remove bits, lock the switch trigger and open the chuck
jaws (Fig. 6).
6. The bit provided with the drill can be placed in the storage
area, located on the base of the drill (Fig. 10).
Fig. 10

Selecting the Direction of Rotation

m
WARNING!
Set the direction of rotation selector in the
OFF (center lock) position to lock the switch trigger and help
prevent accidental starting when not in use.
NOTE: Always check the direction of the cordless drill/driver
rotation before use.
1. To select forward rotation, press the forward selector
switch from right to left flat against the cordless drill/driver
(Fig. 11).
Fig. 11
Forward rotation selector
2. To select reverse rotation, press the reverse selector
switch in the opposite direction (Fig. 12).
Fig. 12
Reverse rotation selector
Bit storage
3. The center position locks the tool (Fig. 13).
Fig. 13
Center
"LOCK"
position
NOTE: The drill/driver will not run unless the direction of
rotation selector is pushed fully to the left or right.
m
CAUTION!
To prevent gear damage, always allow
the chuck to come to a complete stop before changing the
direction of rotation.
m
WARNING!
Battery tools are always in operating
condition. Lock the switch when not in use or carrying at your
side, when installing or removing the battery pack, and when
installing or removing bits.

Starting + Stopping

The variable speed trigger switch delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
1. Set the direction of rotation selector in the OFF
(center lock) position to lock the switch trigger (Fig. 13).
2. Insert the battery in the battery compartment (Fig. 14).
Fig. 14
Battery
10
Direction of
rotation selector
Battery
compartment