Biamp Vocia WR-1 Manual Del Usuario página 6

Menu Structure
The WR-1 has up to four functions that can be configured in the Vocia Software. To pressing the up or
down select buttons will cycle through the programmed menus.
Volume, Source Mute and Source Selection are always available.
Page Inhibit and Zone Mute are enabled or disabled in the Vocia Software on a per-Zone basis.
Display Views
The screens listed below can be cycled through by using the Select, Up and Down buttons:
Volume Screen
from left to right as the number increases. At maximum volume, the bar is at full length. At minimum
volume, the bar is replaced with the word Off. While in this function, the Adjust buttons are used to
increase or decrease the Background Music level.
The volume setting will be restored when the mute is off. While in this function the Adjust up button will
enable the mute and the Adjust down button will disable the mute.
The Volume Screen is the default display screen. If the WR-1 has not been
operated for a period of sixty seconds The WR-1 will return to this screen.
The display shows a number between 0 and 100 in the top right corner, and a bar
graphic represents the volume setting. As volume increases, the bar lengthens
Source Mute Screen
The Source Mute screen provides a mute control for the current selected
background source. The screen shows Source Mute at the top with On or Off
displayed in the lower center of the screen. When Source Mute is on, the
background source is muted and the current background volume setting is stored.
Source Screen
The Source screen provides source selection for the associated background music
channels. The top right of the display will show the current and available number of
defined sources. The lower part of the screen will display a customizable label
WR-1 Operation