Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Installation instructions for part 95-7628BHG
Nissan Murano 2015-up
KIT FEATURES
• ISO DDIN radio provision
• Painted to match factory finish
KIT COMPONENTS
• A) Radio housing trim panel • B) Radio brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-7552
Antenna Adapter: • 40-NI12
METRA. The World's best kits.
95-7628BHG
™
metraonline.com
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DDIN radio provision ...................................... 3
TOOLS REQUIRED
• Panel removal tool
• Phillips screwdriver
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
© COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
Publicidad
Manuales relacionados para Metra 95-7628BHG
Resumen de contenidos para Metra 95-7628BHG
- Página 1 • Panel removal tool • A) Radio housing trim panel • B) Radio brackets • Phillips screwdriver CAUTION: Metra recommends disconnecting the negative battery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for more information.
- Página 2 95-7628BHG Dash Disassembly 1. Slide down the shifter beauty ring 7. Remove (2) Phillips screws securing under the shift knob. (Figure A) the climate control assembly below the radio and then remove. (Figure F) 2. Remove the clip from the shift knob 8.
- Página 3 3. Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio and climate controls. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio for proper operation.
- Página 4 Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians METRA. The World’s best kits. metraonline.com ™ © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION...
- Página 5 INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 95-7628BHG Indice Nissan Murano 2015 y mas 95-7628BHG Desmontaje del tablero ..........Ensamble del kit – Provisión de radio ISO DDIN ........3 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN • Pintura para igualar el acabado de fábrica...
- Página 6 95-7628BHG Desmontaje del tablero 1. Deslice hacia abajo el anillo decorativo 7. Quite los (2) tornillos Phillips que sujetan de la palanca de velocidades debajo de la el conjunto del control de clima debajo del perilla. (Figura A) radio y retire. (Figura F) 2.
- Página 7 Metra recomienda el uso de adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. Vuelva a...
- Página 8 INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 95-7628BHG IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente como se indica en las instrucciones.