Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Kia Amanti 2007-2009
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) Radio housing • B) Radio brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1004 • 70-7303 (2009 model only)
Antenna Adapter: • 40-KI10
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 10mm socket wrench
METRA. The World's best kits.
Installation instructions for part 95-7331
95-7331
metraonline.com
™
Table of Contents
Dash Disassembly ..............................................2-3
Kit Assembly
– ISO DDIN radio provision ...................................... 4
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 95-7331
Resumen de contenidos para Metra 95-7331
- Página 1 KIT COMPONENTS • A) Radio housing • B) Radio brackets CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
-
Página 2: Dash Disassembly
95-7331 Dash Disassembly 1. Unclip the top half of the shift knob and remove the “C” clip securing the shifter. Pull up on the shifter to remove. (Figure A) 2. Unclip and remove the panel surrounding the shifter. (Figure B) 3. - Página 3 95-7331 Dash Disassembly 6. Unclip the rear trim panel from the center console, including the a/c vents. Unplug and remove the rear trim panel. (Figure E) 7. Remove (1) Phillips screw from each side at the rear of the center console. (Figure E) 8.
-
Página 4: Kit Assembly
Installation instructions for part 95-7331 Kit Assembly IMPORTANT ISO DDIN radio provision If you are having difficulties with the installation of this product, please call our 1. Snap the switches removed in dash Tech Support line at 1-800-253-TECH. disassembly into the radio housing, in... -
Página 5: Componentes Del Kit
Instrucciones de instalación para la pieza 95-7331 Indice Kia Amanti 2007-2009 95-7331 Desmontaje tablero ..........2-3 Ensamble del kit – Provisión de radio ISO DDIN ......... 4 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN COMPONENTES DEL KIT • A) Carcasa del radio • B) Soportes del radio ¡PRECAUCIÓN! -
Página 6: Desmontaje Tablero
95-7331 Desmontaje tablero 1. Desenganche la mitad superior de la perilla de velocidades y quite el gancho en “C” que sujeta la palanca de velocidades. Jale la palanca de velocidades hacia arriba para quitarla. (Figura A) 2. Suelte y retire el panel que rodea la palanca de velocidades. - Página 7 95-7331 Desmontaje tablero 6. Desenganche el panel de moldura trasero de la consola central, incluyendo las rejillas del aire acondicionado. Desconecte y quite el panel de la moldura trasera. (Figura E) 7. Quite (1) tornillo Phillips de cada lado de la parte trasera de la consola central.
-
Página 8: Ensamble Del Kit
Instrucciones de instalación para la pieza 95-7331 Ensamble del kit IMPORTANTE Provisión de radio ISO DDIN Si tiene dificultades con la instalación de este producto, llame a nuestra línea 1. Coloque a presión los interruptores que quitó al desarmar el tablero en la carcasa de soporte técnico al 1-800-253-TECH.