Metra 95-7369B Instrucciones De Instalación página 3

1. From the factory radio trim panel,
remove (2) screws from each vent,
attach them into the radio trim panel,
and then secure using the same screws.
2. From the factory radio trim panel,
remove (4) panel clips, and then attach
them onto the radio trim panel.
3. Attach the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
5. Secure the completed assembly into the
dash using the factory screws.
6. Snap the radio trim panel over the
completed assembly and then reassemble
the dash in reverse order of disassembly.
KIT ASSEMBLY
(Figure A)
3
REV. 9/25/2017 INST95-7369B