Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Subaru 2012-2015
KIT FEATURES
• ISO DDIN radio provision
• Painted Matte Black
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets
A
B
Forester
(without NAV)
Impreza
(without NAV)
METRA. The World's best kits.
Installation instructions for part 95-8905B
95-8905B
APPLICATIONS
SUBARU
2014-2015
WRX
(without NAV)
2012-2014
XV Crosstrek
(without NAV)
2015
2013-2014
metraonline.com
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DDIN radio provision ...................................... 3
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Small Flat Blade Screwdriver
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-7552
Antenna Adapter: • Not required
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION

Publicidad

loading

Resumen de contenidos para Metra 95-8905B

  • Página 1 Wiring Harness: • 70-7552 Antenna Adapter: • Not required CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for more information. All accessories, switches, climate...
  • Página 2 95-8905B Dash Disassembly 1. Disconnect the air selector cable 4. Unclip and remove the trim panel located on the driver’s side of the surrounding the factory radio center console, behind the dash including the a/c vents and climate and above the gas pedal. (Figures controls.
  • Página 3 (Figure B) 3. Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio for proper operation.
  • Página 4 Installation instructions for part 95-8905B IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
  • Página 5 Instrucciones de instalación para la pieza 95-8905B Indice Subaru 2012-2015 95-8905B Desmontaje del tablero ......... 2 Ensamble del kit – Provisión de radio ISO DDIN ......... 3 CARACTERÍSTICAS DEL KIT HERRAMIENTAS REQUERIDAS • Provisión de radio ISO DDIN • Herramienta para quitar paneles •...
  • Página 6 95-8905B Desmontaje del tablero 1. Desconecte el cable selector de 4. Desenganche y quite el panel de aire del lado del conductor de la moldura que rodea el radio de consola central detrás del tablero fábrica, incluyendo las rejillas del sobre el pedal del acelerador.
  • Página 7 Metra recomienda que use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. Vuelva a conectar la terminal negativa de la batería y pruebe el radio para verificar que funcione correctamente.
  • Página 8 Instrucciones de instalación para la pieza 95-8905B IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...