Rainfall; Rainfall History; Total Rainfall; Rainfall Alarm - Oregon Scientific RGR682 Manual De Usuario

If necessary, adjust the level using the screw.
NOTE
For best results, ensure the base is horizontal to
allow maximum drainage of any collected rain.

RAINFALL

Today's rainfall appears on the 1st line of the display and
total rainfall is shown on the 2nd line. Press IN / MM to
toggle between inches and millimeters.

RAINFALL HISTORY

The rainfall history is displayed on the second line of the
LCD display. The main unit can record and store up to nine
days of rainfall.
To display the record for a particular day:
Use HISTORY / UP to toggle between daily rainfall and
rainfall history over the past nine days. The day of the record
will be displayed with a minus (-) sign. Zero (0) means the
record is for the current day.
To clear the current day's rainfall:
Press and hold SINCE for two seconds. Note that this will
also clear the total rainfall record.
CAUTION
Other sensors using the 433 MHz transmission
frequency may influence the rainfall reading. Please avoid
placing those sensors too close to the unit.

TOTAL RAINFALL

The total rainfall is displayed on the 1st line of the LCD
display.
To display the commencing date of the total rainfall record,
press SINCE. The date will appear on the bottom line of
the display.
To clear the existing commencing date and reset it to start
again, press and hold SINCE. The total rainfall and today
rainfall will be reset to zero and the unit will start again to
collect the rainfall data.

RAINFALL ALARM

The rain alarm value can be displayed at any time by
pressing RAIN .
To set the rainfall alarm:
1. Press and hold RAIN
2. Use HISTORY / UP or DOWN to set the desired value.
3. Press RAIN to confirm. The alarm will be activated.
5
for two seconds.