Hella BST SLIM Instrucciones De Montaje página 23

EN
Electrical connection / Surface Mount
For Synchronization:
Connect YELLOW wires of all heads to-
gether for synchronization (all heads must
be set at the same pattem)
For Simultaneous or Alternating Flash:
1. Apply +VDC to RED and YELLOW wires
simultaneously to enter Grouping mode;
lighthead will display short (single or
double) flashes:
23
• Single flash = Group 1
• Double flash = Group 2
2. Remove YELLOW wire from +VDC and
momentarily apply to +VDC to change
Groups:
• Heads in the same Group flashtogether.
• Group1 Heads alternate with Group2
Heads.
For Flash Patterns:
Momentarily apply +VDC to
YELLOW wire:
• once for next pattern
• quickly three times for pattern 0
3/6 x LED / R65
FP-Nr. flash sequence:
0 Triple *
1 Single *
2 Double *
3 Triple *
4 Quadruple *
5 Steady
3 x LED / SAE
FP-Nr. flash sequence:
0 Double
1 Single
2 Double
3 Triple
4 Quadruple
5 Quint
6 Mega
7 Giga
8 Ultra
9 Steady
* Only the flash patterns 1, 2, 3,
and 4 are approved for use in
Europe.
6 x LED / SAE
FP-Nr. flash sequence:
0 Double
1 Single
2 Double
3 Triple
4 Quadruple
5 Quint
6 Mega
7 Giga
8 Ultra
9 Steady
10 Single (split)
11 Double (split)
12 Triple (split)
13 Quadruple (split)
14 Quint (split)
15 Mega (split)
16 Giga (split)
17 Ultra (split)
red / blue
FP-Nr. flash sequence:
0 Triple (split)
1 Triple (red only) [R 65]
2 Triple (blue only) [R 65]
3 Single (split)
4 Double (split)
5 Triple (split)
6 Quadruple (split)
7 Steady (red only)
8 Steady (blue only)