Troubleshooting - Stanley SXAE00125 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
2. Slide the ON/OFF switch to the ON position. Charging should begin automatically. The
display will show which port is in use.
3. Charging time will vary, based on the mobile device's battery size and the charging port
used. NOTE: Most devices will charge with either USB port, but may charge at a slower rate.
4. When finished using the USB port, disconnect the charging cable from your mobile device
and then disconnect the charging cable from the unit. Slide the ON/OFF switch to the OFF
position.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will automatically shut off after 30
seconds.
3.4. Maintenance
After unplug and disconnect the unit, use a dry cloth to wipe all battery corrosion and other dirt or oil
from the battery clamps, cords, and the outer case.
3.5. Storage
 Charge battery to full capacity before storage. Charge at least once every month, if not in frequent
use, to prevent over-discharge.
 Store this unit at temperatures between -10°C- +40°C.
4.

Troubleshooting

4.1. Booster
PROBLEM
The booster's display will not turn on.
The LCD Display is flashing.
The booster will not recharge.
The booster turns on, but won't jump start
my vehicle.
When cable is correctly connected to both
battery and booster: Green LED blinking;
Red LED off; no beep.
SOLUTION
Make sure the unit is charged.
Connect to a power source, to reset.
Make sure the ON/OFF switch is set to the ON
position.
The unit is too hot or cold. Disconnect the output lead
& Micro/USB charging cable. Connect when the
condition is removed.
Make sure the power source is live.
Check connections.
Verify the charge level of the booster is at least 40%.
Do not attempt to jump start your vehicle more than
three consecutive times. If the vehicle still does not
start, consult a qualified service technician.
"Fake" high battery voltage is detected, but reverse
charging protection did not activate. You can turn key
to jump start the vehicle.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido