General Description; Electricity Supply - GYS GYSTART 724E Manual Del Usuario

GENERAL DESCRIPTION

Thank you for choosing this GYS product which has been designed with great care. To get the best out of
your machine, please read the following instructions carefully, and keep for future reference.
The GYSTARTs are designed to start vehicles with liquid or gel electrolyte lead-acid batteries and also charge
liquid or gel electrolyte lead-acid batteries. They are for use on 12V or 24V batteries with a capacity
according to the table below :
GYSTART
Charge
Start

ELECTRICITY SUPPLY

This device must be plugged into an EARTHED power supply with the following characteristics :
Voltage
Protection
Recommended cable section for use on extension cables: 3 x 2.5 mm² (4 x 2.5 mm² for the 1224T).
USE IN STARTING MODE (START)
Prior precautions
• Do not disconnect the battery from the vehicle. If the battery is disconnected it can lead to information being lost
and possible failure in starting the vehicle.
Connecting and disconnecting
Switch off the product by selecting position "0".
•
Connect the clamps: red to + terminal, black to – battery terminal. Select the correct voltage 12 or 24 V
•
for the battery.
Switch on the product by selecting "I"
•
• Proceed to pre-charge (if necessary) for a few minutes with a current of about 1/5
Sit behind the steering wheel in order to activate the remote control switch and the ignition at the same time.
•
• A 5 second period is usually enough to start. Repeat the operation if needed.
• When the engine's motor starts, release the remote control switch and switch the device off - position « O ».
• Disconnect the clamps from the battery.
• In « Electronic Control » position, Gystart protects the on-board electronics and avoids overvoltage
( : <14,8V
USE IN CHARGING MODE (CHARGE)
Prior precautions
• Choose a sheltered area with suitable ventilation.
• Remove the battery caps (if present) and ensure the liquid level (electrolyte) is correct. Add some
distilled water if necessary. Carefully clean the lugs and terminals of the battery.
• Check that the capacity (Amps per hour) and the voltage (Volts) are compatible with your charger.
Connecting and Disconnecting
• Switch off the product by selecting position "0". Then plug into the mains supply and turn the charge
current potentiometer to the lowest setting.
• Select the correct voltage 12 or 24 V for the battery.
• Connect the clamps: red to + terminal, black to – battery terminal.
Make sure you get good electrical contact.
• Select the charging mode using the switch :
"Electronic control": when the charging process is over, a light will illuminate.
"Manual mode": stop the charging process when your battery starts to boil.
flames or sparks.
• Switch on the product by selecting "I"
• After one minute of charge adjust the charging current using the control knob.
724E
20>1000 Ah
45>200 Ah
GYSTART 724E
230V single ph.
16A
N EVER disconnect the battery from the vehicle
: <29,6V). In Manual position, this protection is not activated.
924-230 1224T
30>1100 Ah 65>1350 Ah
45>250 Ah 60>300 Ah
924-230 1224T
230V single ph. 400V 3 ph.
40A
Be careful of explosive gas, avoid
16A
th
of the battery's capacity.
5