Getac V200 Guia De Funcionamiento página 7

Touchscreen Guidelines

Use the finger or the included stylus on the
display. Using a sharp or metallic object
other than your finger or stylus may cause
scratches and damage the display, thereby
causing errors.

Use a soft cloth to remove dirt on the dis-
play. The touchscreen surface has a special
protective coating that prevents dirt from
sticking to it. Not using a soft cloth may
cause damage to the special protective
coating on the touchscreen surface.

Turn off the computer power when clean-
ing the display. Cleaning the display with
the power on may cause improper opera-
tion.

Do not use excessive force on the display.
Avoid moving the computer while holding
the display or twisting the display. Avoid
placing objects on top of the display as
this may cause the glass to break thereby
damaging the display.

Using the touchscreen during low tempe-
o
rature (less than 5 C) may cause a slower
response time. This is normal. A normal
response time may be restored upon re-
turning to room temperature.

When there is a noticeable discrepancy in
the placement of the stylus on the screen
and the indicated position of the onscreen
pointer, use the calibration utility to reca-
librate the touchscreen display.
Using System Recovery
Use System Recovery when:

The Windows operating system does not
start at all.

You want to restore the system to the
factory state.
WARNING: All data on the hard disk drive
will be lost.
To run System Recovery:
1. Connect the AC adapter.
2. Turn on the computer. During system start-
up when the Getac logo screen appears,
press Ctrl + Alt + F2 keys for four seconds.
3. In the screen that appears, select Recovery
to start the recovery process.
4. The progress bar shows the percentage
completed. When it reaches 100%, the
system turns off.
5. Turn on the computer. The Windows setup
wizard starts. Follow the onscreen prompts
to continue.
6. When the system restarts, the installer
screen appears. The installer will perform
system hardware detection and driver
installation.
7. When completed, the system restarts and
displays Windows desktop.
5