Tripp-Lite B122-000-60 Manual Del Propietário página 3

Installation
Notes:
1. Test to make sure the entire installation works properly before pulling cables through
ceilings/walls.
2. The B122-000-60 and B122-000-4K6 have been designed for use with Tripp Lite P568-Series
HDMI cables. To ensure maximum distance and performance, it is recommended that you use
Tripp Lite P568-Series HDMI cabling. For distances over 75 ft. (23 m), 24 AWG cable such as
Tripp Lite's P568-100-HD is required.
3. Although most installations will not require power, a Micro USB port is provided in the event
power is needed. If an image does not appear after performing the following steps, connect a
Micro USB cable from the port on the unit to a USB computer, monitor or USB wall charger
port, such as Tripp Lite's U280-002-W12.
MONITOR
Connect the longer HDMI cable between the source and the SOURCE port on the
1
B122-000-60 or B122-000-4K6.
Note: When transmitting a 1080p (60 Hz) signal, the HDMI cable connecting the source to the
B122-000-60 must be no longer than 125 ft. (38 m).
2
Connect the shorter HDMI cable between the HDMI monitor and the DISPLAY port on
the B122-000-60 or B122-000-4K6.
Note: The HDMI cable used to connect the monitor to the B122-000-60 or B122-000-4K6
must be no longer than 16 ft. (5 m).
Specifications
Model
Max Resolution
Compliance
Operating Temperature
Storage Temperature
Relative Humidity
19-01-055-93372B.indb 3
B122-000-60
1920 x 1200 @ 60 Hz
(up to 125 ft. / 38 m)
HDCP 1.4, HDMI 1.4
32°F to 104°F / 0°C to 40°C
5°F to 122°F / -15°C to 50°C
0 to 85%, non-condensing
3
BLU-RAY
B122-000-4K6
3840 x 2160 @ 60 Hz
(up to 50 ft. / 15 m)
HDCP 2.2, HDMI 2.0
1/11/2019 11:28:22 AM