Publicidad
Idiomas disponibles
Idiomas disponibles
Important safety instructions
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Clean only with dry cloth.
Install in accordance with the manufacturer's instructions.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not ope rate normally, or has been dropped.
No naked flame sources, such as lighted candles should be placed on
the apparatus.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Compliance with 2014/53/EU Radio Equipment Directive (RED)
In accordance with Article 10.8(a) and 10.8(b) of the RED, the following
table provides information on the frequency bands used and the
maximum RF transmit power of the product for sale in the EU:
Frequency range (MHz)
2402~2480MHz
The product firmware is available for download from the Bang & Olufsen
App.
Software / Firmware: V1.04
Accessories: Beoplay H9 3rd Gen unit, USB Cable, Audio cable, Flight
adaptor, Quick start guide & Important Information.
The product to be sold in all European Union member and EFTA countries.
Hereby, Bang & Olufsen A/S declares that the radio
equipment type Beoplay H9 3rd Gen is in compliance
with Directive 2014/53/EU. The full Declaration of
Conformity can be found at the following web site:
https://www.bang-olufsen.com/support/beoplay-h9
Max. Transmit Power (dBm)
5.94dBm±2dBm
4
Publicidad
