Shark HH200 Serie Guia Del Propietario página 4

MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.
EMPTYING THE DUST CUP
Empty the dust cup each time you vacuum and periodically during cleaning, when debris in the dust cup
reaches the MAX fill line.
To remove the dust cup from the handheld vacuum,
press the two Dust Cup Release buttons at the same
time and slide out the dust cup.
To reinstall, push the lid closed, then insert the
front end of the dust cup into the handheld vacuum
first, then the back end, until it clicks into place.
s h a r kc l e a n . c o m
(Click)
Hold the dust cup over the trash. Press the Empty
button and pull the dust cup open until it clicks
and locks in the open position. Gently tap the
cone-shaped screen inside the dust cup to knock
dust and debris into the trash.
MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.
CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
PRE-MOTOR FILTERS
With the dust cup detached, press the Filter
Access buttons on both sides of the back of the
dust cup, then pull out the filter housing. Pull the
foam filter out of the housing, then lift out the felt
filter by the pull tab.
The Pre-Motor Filters should be washed
once a month.
REPLACEMENT FILTERS
Replacement Pre-Motor Filter Kit
XFFKHZ2000
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
POST-MOTOR FILTER
To access the post-motor filter, press the Filter
Access latch on the filter cover. Remove the cover
and lift the out filter.
The Post-Motor Filter should be washed once
every 9 months.
Replacement Post-Motor Filter
XPMFHZ2000
s h a r kc l e a n . c o m