ASROCK X99 Extreme6/3.1 Manual De Instrucciones página 36

Installation Procedure
he ASRock USB 3.1 Card/A+A provides two external USB 3.1 ports which support
transfer rates up to 10 Gbps. Follow the simple steps below to install the ASRock USB 3.1
Card/A+A.
Step 1
Power of the PC and unplug the power cord. Detach all other cables from the PC.
Step 2
Remove the side panel from the computer case.
*Refer to the documentation that comes with your PC for details.
Step 3
Locate an available x4, x8 or x16 PCI Express slot on your motherboard and remove its
slot bracket.
*To maximize the performance of ASRock USB 3.1/A+A, it is highly recommended to
insert the card into the PCIE3 (from CPU) if the slot is not occupied by graphics card. If
the PCIE3 is occupied, insert the card into PCIE5 (from CPU) .
Step 4
Align the ASRock USB 3.1 Card/A+A with the PCI Express slot and press down irmly
until it is fully seated in the slot. hen secure the card with the slot bracket's holding
screw.
Step5 (Optional)
Install PSU's 4-pin power cable to ASRock USB 3.1 Card/A+A's 4-pin Power Connector.
*If your USB device consumes more than the standard 0.9 Amps, we suggest following
this step to provide extra power for this card. If the power consumption of your USB
device is standard compliant (equal to or lower than 0.9 Amps), you can skip this step.
Step 6
Replace the side panel. Reconnect the power cord and any other cables that were
disconnected.
34