Steam Ironing; After Use - Tristar ST-8911 Manual De Usuario

BeFoRe The FIRST uSe
• Before the first use, please remove any sticker or protective cover.
• Place your steam generator on a stable, horizontal heat-resistant
surface.
• For the first use, use the iron on an old piece of fabric to ensure the
soleplate and water tank are completely clean.
• Never use the steam generator when water tank is empty, refill it
before use it again.
Fill the water tank
• Before filling the water tank, check if the steam generator is cooled
down, if the power cable is unplugged and if the temperature knob is
on its minimum position.
• Note: never unscrew the boiler cap before these three steps are done.
• During filling please do not exceed the maximum water capacity (0.5L).
• Note: use a funnel to fill the boiler.
• Please read carefully our advices in chapter "type of water to use"
concerning the water to use with your steam generator.
• Open the boiler filter cap and fill the boiler with water.
• Screw the boiler filter cap tight.
• Notes: if the water tank indicator illuminates and there is no steam the
water tank is empty.
• Never unscrew the boiler cap when the appliance is still connected to
the power supply.
Select the temperature
• Place the iron on its base.
• Select the desired temperature by using the thermostat knob, check the
ironing symbols on your clothes in order to adapt the ironing temperature.
• Note: we advise you to read the chapter "Ironing of your linens" in order
to select the best ironing temperature.

STeam IRoNINg

Note: For the first use, use the iron on an old piece of fabric to ensure the
soleplate and water tank are completely clean.
• Fill the boiler and select the temperature as described before.
• Plug the power cable into the wall outlet.
• Turn on the device by using the ON/OFF button, the unit will be heated up.
• It will take around 5 minutes to produce enough steam, the steam
ready and empty water tank indicator light will be illuminate when the
iron is ready for use.
• Note: Do not use the steam function before the steam ready indicator
illuminates.
• There are two ways to obtain steam,
o Press on the steam switch button beneath the iron handle and keep
it pressed. The steam will stop when you release the button.
o By pressing the steam lock button steam and slide the steam lock
backwards, the iron will steam now constantly.
Note: The first time the steam generator is used, there may be some smoke
and smell, this is not harmful. They will not affect the performance and will
disappear rapidly.

aFTeR uSe

• Put the temperature knob on minimum position.
• Turn off the device by using the ON/OFF button.
• Unplug the power cable.
• Wait until the steam generator and the soleplate are cooled down
completely.
• Unscrew the boiler cap and pour out the remaining water then place
the boiler cap back on the unit.
Steam generator iron
eN
5