Plidco Flange+Repair Ring Manual Del Usuario página 11

PLIDCO offers hydraulic sealant pumps with standard and long barrels. There are three different pump
variations you could choose from: Hand pump, foot pump, and air pump. They all utilize standard
hydraulic fittings and are interchangeable between units. Figure 6 shows the different variations on the
pumps. All units come in a Pelican
1.) Figure 6 above shows how to assemble the units after removing them from the case.
2.) To insert sealant into a sealant barrel, make sure the piston is at the bottom of the barrel. Figure
7 shows how to push the piston in. The connected hydraulic pump needs to be in the release
position to allow oil to flow back into the pump. The piston is a very tight fit. A hammer may be
needed to drive the piston back. If the supplied piston plunger is lost, a piece of pipe or handle of
a hammer may be used to drive the piston back.
PLIDCO Hydraulic Sealant Pump
®
case for storage between uses.
Figure 6
Assembly
Figure 7
Page 10 of 12 IP-008
Revision 1