Operation; Restarting A Warm Engine - MAT Engine Technologies Powermate PRTT196E Manual De Operación

Operation

• Save all instructions
A
Pre-Start Inspection
1. Make sure all safety guards are in place and all nuts and
bolts are secure.
2. Check oil level in engine crankcase. See your engine
manual for procedure and specifications.
3. Inspect air cleaner for cleanliness. See your engine
manual for procedure.
4. Check the fuel supply. Fill the fuel tank no closer than 1
inch from top of tank to provide space for expansion.
See your engine manual for fuel recommendations.
5. Be sure spark plug wire is attached and spark plug is
tightened securely.
6. Check position of wheels and wheel lockouts.
7. Check depth regulator lever position.
8. Examine underneath and around engine for signs of oil
or fuel leaks.
9. Inspect fuel hoses for tightness and fuel seepage.
10. Look for signs of engine damage.
11. Remove excessive debris from muffler area and recoil
starter.
IMPORTANT: Engine is shipped from factory without oil. YOU
MUST ADD ENGINE OIL BEFORE STARTING ENGINE.
B
Start-Up
The controls required to start and run the tiller are located on the engine and are marked with the icon for choke, slow
and fast for the throttle, and on/off fuel valve. A more detailed description of engine operation and all related precautions
and procedures can be found in the engine manufacturer's manual that accompanies each tiller.
COLD STARTS
1. Turn the Engine Switch to the "on" position.
2. Open the Fuel Valve.
3. Move choke lever to left for full choke position.
4. Move throttle lever to "start" or "fast" position.
5. Pull starting rope out slowly one time and allow to return
normally.
6. Pull starting rope out rapidly, and allow rope to return
normally.
7. When engine starts, gradually move choke lever to "no
choke" position and increase throttle speed.
Questions? Call Toll Free at 1-800-737-2112
CAUTION
Please do not start your tiller until you have read the
manual that came with your tiller, and the sections in this
manual tiller controls, adjustments and safety. If you have
read these, follow the steps below to start your tiller. Always
perform this pre-start checklist before starting the engine.
WARNING
Gasoline is highly flammable and must be handled with
care. Never fill the tank when the engine is hot or running.
Always move outdoors to fill tank.
Wheels must always be locked in the tilling position when
engine is running. Do not operate the tiller with the wheel
lockouts unlocked. Always set the wheels in tilling position
before starting engine.
Always put depth regulator lever in the transport position
before starting engine. Tines should clear ground.
DANGER
Always keep hands and feet clear of rotating machine parts.

RESTARTING A WARM ENGINE

Restarting an engine that is already warm from previous
running does not normally require use of the choke.
1. Move throttle lever to "start" position or "fast" position.
2. Pull starting rope out rapidly until engine starts. Allow
rope to return normally. Repeat until engine starts.
3. Adjust throttle speed to "fast" for best tiller performance.
Copyright © 2012 MAT Engine Technologies, LLC
11