GAP Supply VQ-LED-600WW Manual De Instalación Del Uso Y Mantenimiento página 7

pairing instructions
1
Option 1
zone 1
All receivers in one zone
zone 1 zone 2 zone 3
Option 2
Each receiver in different zonez
1. If you use multiple receivers, you have two choices:
(1) have all the receivers in the same zone, like zone 1, or
(2) have each receiver in a different zone, like zone 1, 2, 3 or 4.
4
4. To "pair" you need to quickly and rmly press and release
the "Learning" button on the receiver and immediately after
that, you will need to quickly press and release the ON or
OFF button on the RAZ-Q4RF control for the zone you want
to use.
After you have wired all the receivers according to your project requirements, do the following:
2
zone 4
2. In order for each receiver to know what Zone it belong to,
you will need to "pair" it to the zone you wish to use. In
order to do this,you need to power up the unit with the LED
lights hooked to it.
5
5. Once you do that, the lights will blink once.
Now your Remote and Receiver are paired.
3
3. Reset the receiver by pressing and holding the "Learning"
button until the lights blink 2 times.
X1
X2