Microsonic EPT 800 Serie Manual De Instrucciones página 22

360 0 calefactor infrarojo eléctrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
Warning: Please assemble the heater according to the following procedures, and
make sure the electric wiring is connected properly and segments of the center
pole are properly secured
(1)
Remove all parts out of the carton and plastic covers and place these parts on the floor, carpet
or carton paper for assembly. THIS HEATER IS HEAVY Check the heater for any potential
damage due to shipping.
Remove the fifteen (15) screws from the plastic package provided for assembly.
(2)
(3)
Insert the heating element wiring and connecting plug leading from the heating elements
through that segment (with the warning label) of the center pole (standing tube) as shown in
Drawing 1.
(4)
Align the screw holes on this segment of the center pole with those on the heating element
assembly and connect this segment of the center pole to the heating element assembly and
secure the same with three (3) of the screws provided as shown in Drawing 1 and, after all
three (3) screws are in place, tighten the screws to secure the segment(s) properly
(5)
Insert the base wiring through the segment of the center pole (standing tube) as shown in
Drawing2.
(6)
Align the screw holes on this segment of the center pole with those on the base assembly
and connect this segment of the center pole to the base assembly and secure the same with
six (6) of the screws provided as shown in Drawing 2.and, after all six (6) screws are in
place, tighten the screws to secure the segment(s) properly.
Drawing 1

Publicidad

Tabla de contenido
loading

Tabla de contenido