Assembly; Tools Needed For Assembly - LEGEND FORCE LFEA528 Guía De Uso Y Cuidado

Assembly

PARTS INCLUDED WITH THE EARTH AUGER
Part Description
A 52cc Auger Powerhead
B 8 in. Auger Bit (Included for Model LFEA528)
C Fishtail Point
D 14 mm Wrenches
E M10-1.5 X45 Bolt & Locknut
F 2-Cycle Engine Oil Bottle
WARNING: Do not operate Earth Auger if it is damaged or
not securely and fully assembled.

TOOLS NEEDED FOR ASSEMBLY

Adjustable
wrench
1
To Assemble Auger Bit
□ Insert the shaft of a large Phillips screwdriver into the cross
hole in the adapter (13).
□ Hand tighten the Fishtail Point (C) into the opposite end of the
adapter. Avoid contact with the Earth Blade (14) and cutting
edge of the Fishtail Point (C).
□ Grip the side of the Fishtail Point (C) with an adjustable
wrench and tighten while holding the Phillips screwdriver to
secure the Auger bit (B) from rotating.
2
To Assemble Auger Bit to Powerhead
□ Move the On/Off Switch (3) to the off position.
□ Remove the Spark Plug (7) boot from the Spark Plug (7) and
secure the boot away from the engine and frame.
□ Insert the Powerhead (A) output shaft into the Auger Bit
adapter (13) and align the top hole of the Auger Bit (B) to the
hole at the output shaft.
□ Insert the bolt (E) through the hole in the Adapter (13) and
Powerhead shaft (A).
□ Install locknut (E) and tighten with wrenches provided (D).
□ Reinstall the Spark Plug (7) boot onto the Spark Plug (7).
Quantity
1
1
1
2
1
1
Large Phillips
screwdriver
6
A
3
7
13
E
B
F
14
D
C