KUBUS W3 Scan Manual Del Usuario página 37

5. MANTENANCE
5.1 Charging the probe
Charge the probe when battery is low via its USB charger. Turb off the probe
previously by pressing a few seconds the centre button. You can use any
USB port for charging (PC, wall, or power bank). During charge, the indicator
light will turn red. When the light turn's blue, the battery is fully charged.
Once the charging process is completed, disconnect the USB, and seal the
charge port with the watertight seal to protect from water.
5.2 Cleaning
After each scan, clean the outer layer of the probe with tap water, a wet
towel or wet wipes. The probe can be cleaned with running water, but
never submerge.
5.3. Storage
When we have finished using the probe, store with care in its bag and in its
padded case to avoid bumps and knocks. Store at a temperature between
0-40°C