DESA Specialty Products Heath Zenith SL-5309 Manual Del Usuario página 3

TEST AND ADJUSTMENT
❒ Turn on the circuit breaker and light switch.
NOTE: Sensor requires about 1
before it will detect motion. When first turned
on, wait about 1
❒ Turn the SENSITIVITY (SENS) control to the mid
position and the ON-TIME control to the TEST
position.
ON-TIME
10 5 1 TEST
Bottom of Sensor
Avoid aiming the control at:
• Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light-colored objects reflecting light
may trigger the shut-off feature. Do not point other
lights at the sensor.
8 ft.
(2.4 m)
Maximum
Range
The control is most sensitive to motion across it.
Motion
Least Sensitive
595-5496-06
1
/ minutes to calibrate
2
1
/ minutes.
2
SENS
MIN MAX
60 ft.
(18.3 m)
Maximum
Coverage Angle
Motion
Sensor
Most Sensitive
❒ Loosen the clamp screw in
the sensor ball joint and gen-
tly rotate the sensor to aim.
❒ Walk through the coverage
area noting where you are
when the lights turn on.
Move the sensor head up,
down, or sideways to
change the coverage area.
❒ Set SENSITIVITY as needed.
Too much sensitivity may in-
crease false triggering.
❒ Secure the sensor head
into position by tighten-
ing the clamp screw. Do
not overtighten the screw.
❒ Set the amount of TIME the
lights stay on after motion is
detected. It is selectable from
1, 5, or 10 minutes.
SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 60 ft. (18.3 m); [varies
Sensing Angle . . . . . . . Up to 110°
Electrical Load . . . . . . . Up to 300 Watts Maximum
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
110°
Time Delay . . . . . . . . . 1, 5 or 10 minutes
Sensitivity . . . . . . . . . . Adjustable
Replacement lamp . . . T 300W (or less) halogen 120
DESA Specialty Products™ reserves the right to dis-
continue products and to change specifications at any
time without incurring any obligation to incorporate new
features in products previously sold.
3
Clamp
Screw
Ball
Joint
Aim Sensor Down
for Short Coverage
Aim Sensor
Higher for Long
Coverage
with surrounding temperature]
Tungsten
MODE
VAC