jet vag JUNIOR Manual De Instalación página 12

2.
mounting the facade
JUNIOR /JUNIOR PRO
pic 1
2
1
pic 2
pic 3
pic 4
pic 5
pic 6
ALVÉO'NOX NEW JET VAG
• After the installation of the sealing part (see:
manuel: Sealing part), remove the protection
plate (pic 1)
• Identify the two outputs at the back of the
part to be sealed (pic 2) :
The output 1 with a foam (filter) represents
the air tube. Place it above the water level,
in the open air (pic 3)
For a pneumatic control, output 2 allows
the control tube to pass through. The latter
must connect the electrical box to the
button on the façade (pic 3)
For an electrical control, output 2 allows
the passage of the piezo cable. The latter
must connect the electrical box to the piezo
button.
 Tip: To facilitate assembly of the control tube,
insert a wire (electrical or other) through the pipe
until it reaches the junction box. Use this thread as
a «needle» to guide the control tube through the
pipe (pic 4)
• Use the heat-retractable sheath to cover the
4 sleeves of electrical connections (pic 5)
• Heat the sheath to retract it (pic 6)
• Fit the front onto the part to be sealed
• Assemble using the 3 M5 screws
12
JUNIOR / JUNIOR PRO - ALVÉO'NOX - NEW JET VAG - PRO LUXE - LUM JET VAG
PRO LUXE
cas commande électrique