Master Plumber 235817 Manual Del Usuario página 4

Installation
Figure 4
5. Power Supply: This pump requires a 115 V,
60 Hz, 15 amp individual branch circuit. The
circuit must be grounded and should be
dedicated to the sump pump. The pump
is supplied with a 3-wire cord set with
grounding-type plug. Plug the switch directly
6205 1215
into the outlet and plug the pump into the
opposite end of the switch' s plug.
Risk of electric shock. Can
shock, burn or kill. Always ground the pump
to a suitable electrical ground, such as a
grounded water pipe, a properly grounded
metallic raceway, or a ground wire system.
Do not cut off the round ground pin.
For parts or assistance, call Master Plumber Customer Service at 1-800-628-9439
Figure 5
6. After you have installed the piping, check
valve, and float switch, the pump is ready for
operation.
Check the pump by filling the sump
with water and observing the pump' s
operation through one complete cycle. For
6206 1215
switch settings see Electrical and Switch
Specifications.
Risk of flooding. Failure to make
this operational check may lead to improper
operation, premature failure, and flooding.
4