Descargar Imprimir esta página

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Enlaces rápidos

PDS-242_E
2003.12.11 11:23
1
To ensure correct usage
I Always use at least two people to perform installation work.
Injury could result from dropping heavy objects.
I Use the specified bolts and screws in the specified places and tighten firmly.
Failure to do this could cause injury if the plasma monitor falls.
Securing to a wall or post
Using the hooks at center of the rear of the plasma monitor, a
commercially available cord or chain, and a clamp, secure the
set to a firm wall or to a wall post.
Hook
Cord or
chain
I Do not mount the plasma monitor in an unstable location.
The monitor could fall or break, resulting in physical injury.
I Do not block the ventilation holes. Ensure that there is sufficient clearance for ventilation.
The internal temperature of the plasma monitor could elevate possibly resulting in fire.
I Avoid installing in locations where the temperature and humidity are excessively high,
and where contact with water is possible.
These can result in fire or electrical shock.
I Do not alter any parts or use broken parts.
This could result in the plasma monitor falling causing injury.
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE
YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND
YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN
YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA
WARNING
CAUTION
Securing to a tabletop
Using commercially available wood screws
(two), fasten the set to the clamping screw
holes on the rear of the pedestal as shown.
Cord
or
chain
Clamp
2003
Printed in Japan
PDS-242
Pedestal
Wood
screw
(Two places)
Thank you for purchasing the Pedestal.
To ensure correct usage, please read this instruction manual thoroughly. After reading,
please store this manual in a safe place for future reference.
This pedestal is for use only with the following models:
PDM-4210, PDM-4210E
I Request an installation specialist to install this unit.
I YAMAHA assumes absolutely no responsibility for injuries and damages that may
occur due to improper installation and handling.
All rights reserved.
3023575
IP
Installation Instructions

Publicidad

loading

Resumen de contenidos para Yamaha PDS-242

  • Página 1 YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND Installation Instructions YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...
  • Página 2 PDS-242_E 2003.12.11 11:23 Parts Configuration Chart Assembly Method Prepare a phillips screwdriver before proceeding with assembly. Included in the parts package Assembling the pedestal Attaching the Plasma Monitor to the pedestal 1. Insert the support into the pedestal base and secure it in 2.
  • Página 3 YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND Mode d’emploi YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...
  • Página 4 PDS-242_F 2003.12.11 11:21 Eléments du sur pied Procédure d’assemblage Avant de commencer le montage, munissez-vous d’un tournevis cruciforme. Contenu du sachet fourni Assemblage du sur pied Montage du moniteur plasma sur le sur pied 1. Insérez chaque support sur la base du sur pied et fixez-les 2.
  • Página 5 YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND Aufstellungsanweisungen YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...
  • Página 6 PDS-242_G 2003.12.11 11:25 Nehmen Sie einen Kreuzkopfschraubenzieher zur Hand, bevor Sie sich an die Zubehörteile des Lieferumfangs Zusammenbauverfahren Arbeit machen. In der Zubehörtüte Zusammenbau des Sockels Anbringen des Plasmabildschirms auf dem Sockel 1. Schieben Sie den Träger in die Sockelbasis und arretieren 2.
  • Página 7: Instrucciones Para La Instalacion

    YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND Instrucciones para la Instalacion YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...
  • Página 8 PDS-242_Sp 2003.12.11 11:27 Configuración de las partes Método de instalación Antes de empezar con la instalación, tenga a punto un destornillador Phillips. Incluidos en el paquete de las partes Instalar el pedestal Coloque el monitor de plasma en el pedestal 1.
  • Página 9 YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND Installationsanvisningar YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...
  • Página 10 PDS-242_Sw 2003.12.11 11:30 Medföljande delar Hopmontering Skaffa fram en lämplig stjärnmejsel innan hopmontering påbörjas. Inkluderat i tillbehörspaketet Hopmontering av sockeln Montering av plasmaskärmen på sockeln 1. För in stödpinnarna i sockeln och fäst dem genom att 2. För in stödpinnarna på sockeln i de fyrkantiga hålen på skruva i de fyra medföljande skruvarna (M5 x 20) underifrån plasmaskärmens undersida.