Technical Specifications - MELICONI HP 200 Instrucciones De Uso

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Transmission mode

Carrier frequencies

RF output Power

Operating voltage

- Transmitter

- Receiver

Frequency response

Distortion

Signal/Noise ratio

Channel separation

Maximum transmission distance

Listening time

If the headphones do not produce any sound, or if the audio is distorted or seems to be coming from other sources,

perform the following steps:

1) Ensure that the power supply adaptor is fully plugged into the mains socket and that the cable is connected

correctly to the connector "M" of the base (DC IN).

2) Ensure that the ON/OFF "N" (POWER) switch on the base is on the ON position.

3) Make sure that the batteries are completely charged. If necessary, recharge them.

4) Ensure that the audio cable connectors are correctly and fully plugged into the sockets and that the TV or the audio

device is ON and outputting an audio signal.

5) Ensure that the "S" RED indicator (SIGNAL) on the base is constantly on when there an input audio signal. If

necessary, increase the volume of the audio source

6) Switch off the headphones with the "A" (POWER) switch on the earpad and move close to the base.

7) Switch on the headphones and check that the "A" RED indicator (POWER) on the headphones switches on.

8) Press the "C" AUTO SCAN button on the headphones for a moment and wait for the green indicator inside to switch

on.

9) Use the volume control wheel on the headphones to adjust the volume.

10) If the problem persists, use the selector "O" (CHANNEL) on the base to change the channel (1-2-3), and repeat the

procedure from step 6.

• Read this instruction manual carefully, which will help you to find a solution to most problems.

• Consult our website: www.meliconi.com