Operation - ceramill Therm DRS Modo De Empleo

A P P L I C A T I O N
When using the firing tray:
▷ Place glazing objects with ceramic pins on the
E N
firing tray.
▷ Open the furnace door by pressing button
the display.
▷ Place the firing aid with the sintering objects at
the front on the sintering base.
Fig. 23 Firing aid with sintering object
NOTE:
Damage of the sintering objects!
▷ Ensure that the sintering objects do not collide
with the heating element when shutting the
door.
▷ Press and hold the
furnace door is supposed to close. Check the
clear space around the sintering objects.
▷ Release
The door stops at the current position.
42
button for as long as the
button as required.
7.3

Operation

▷ Switch the furnace on via the main switch.
▷ Define the sintering program, if required (see
on
Chapter 6.2).
▷ Open the furnace door by pressing button
the display.
▷ Place firing aid with sintering objects on the sin-
tering base (see Chapter 7.2).
▷ Close the furnace door.
▷ Start the sintering program (see Chapter 6.3).
After the program has elapsed, the heating
cycle automatically switches off.
After the program has ended, the furnace door
can open automatically while still hot, depending
on the program type. An acoustic signal sounds. A
corresponding warning is indicated on the display.
P1 High speed dry
950°C
Fig. 24 Hot furnace warning
WARNING:
Danger of burning!
▷ To remove the sintered objects when the fur-
nace is hot, use tweezers from the delivery
scope or a suitable other tool.
Caution hot! 00:00
on