Arm's Reach Co-Sleeper Cambria Manual De Instrucciones página 4

How to set up the Co-Sleeper brand bedside bassinet
A
H
H
A
H
J
WARNING:
Make sure all Velcro straps are secured and tight .Periodically
check your product to make certain all Velcro and screws are tightened securely.
To convert to Co-Sleeping position
FALL HAZARD:
bassinet before starting any conversions.
A
H
®
A
A
H
B
H
A
H
®
Remove infant from the Co-Sleeper brand bedside
A
G
LOCK
UNLOCK
LOCK
UNLOCK
Step 4
®
Attach all the Velcro straps located at the two sides
of the unit outside of the sleeping nest per picture.
®
Attach all the Velcro located at the front left and
right side of the unit inside of sleeping nest.
Step 5
®
Attach the Velcro under the arch top panel of side
panel .
®
Get the Velcro strips on the lining through the
grooves at the bottom of arch top panel of the side
as picture, attach the Velcro strips back . Repeat
the same process at the opposite side panel.
Step 6
Secure the tie of Storage basket to each leg as
picture.Secure the Velcro flaps of storage
basket short side by attaching the Velcro to the
short storage basket rail. The Unit is now in a free
standing bassinet position.
®
Step 1
Release the Velcros located at the front left and
right side of the unit inside of sleeping nest.
Repeat the same process on other side.
Pull fabric to expose spring lock on the right side.
Slide spring lock towards left, and drop removable
rail down.
Step 2
Insert the end of removable rail(G) into the female
receiver on side panel as picture.
The unit is now in Co-Sleeping position.
4 4
®
®
®
®