Arm's Reach Co-Sleeper Cambria Manual De Instrucciones página 5

How to attach the Co-Sleeper brand bedside bassinet to adult bed
Slide the anchor plate and straps under the mattress, placing the anchor plate flush against the mattress
on the opposite side from Co-Sleeper bassinet. Connect both straps to each short side of the bassinet by
passing the male buckle through the "belt loop" at the front leg of the product and then connect the buckle
to rear leg.
Make both straps as tight as possible against the parental bed, so tight it creates a slight indentation in
mattress. To test if the Co-Sleeper bassinet is tightly secured to adult bed, push product with hands to
make sure the gap is no more than ½"(13mm). If more than ½"(13mm), readjust strap to pull tighter.
When bassinet is tight and ready to use, roll the excess strap up and secure it with elastic loop.
Always tighten straps before each use.
®
To make Co-Sleeper brand bedside bassinet higher, first measure adult bed from floor to top of mattress.
If the adult bed is higher than 24", you will need to raise the Co-Sleeper brand bedside bassinet. Lay the
bassinet on its side. On the bottom of the legs, release the tie of storage basket, find the leg adjuster
mechanism, push button and pull leg .Every time it can be only adjusted one section. After finishing to
raise 4 legs by 2", it is doable to raise the legs by another 2". Repeat the same process until reaching
required bed height (26",28",or 30"). Secure the tie of storage basket to each leg.
It is recommended to make the strap shorter than the width of the mattress to ensure the Co-Sleeper
is pressed securely against the parental bed, without any gaps.
Mattress, Boxsprings &
Frame aligned
ACCEPTABLE BED FRAME IN-LINE
Attension:
bedside bassinet is attached to the adult bed.
®
®
®
The leg extension can only be used when the Co-Sleeper
K
®
UNACCEPTABLE BED,
MATTRESS,BOXSPRING&FRAME NOT IN-LINE
5
®
Frame Extended
®
brand