Shopseries RC4151 Manual Del Usuario página 7

1/4 IN. SHEET FINISHING SANDER
plate.
15.Only use paper in good condition. Do not use torn or
worn paper.
16.Do not sand material containing asbestos due to a
health risk.
17.Do not sand lead based paint due to the risk of lead
poisoning.
18.Do not eat or drink in the working area of the sander.
19.Do not allow people to enter the working area
without wearing a dust mask.
20.Where possible, seal off the working area to contain
the dust for later removal.
21.Your tool is designed for dry sanding only, not wet
sanding.
22.Your tool is designed for general purpose light
polishing of wood and metals.
23.Do not sand magnesium material due to the risk of
fire.
WARNING: Some dust particles created
by power sanding, contain chemicals
known to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
1) Lead from lead-based paint
2) Crystalline silica from bricks and cement and other
masonry products
3) Arsenic and chromium from chemically-treated
lumber
Your risk to these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals:
1) Work in a well ventilated area
2) Work with approved safety equipment, such as those
dust masks that are specifically designed to filter out
microscopic particles.
SYMBOLS
WARNING–To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear dust mask
Wear eye protection
Wear ear protection
ENG
7