OLSON OLDW60X Manual Del Usuario página 55

Fully-integrated model
Install the hook on the aesthetic panel and put the hook into the slot of the outer door of dishwasher (see figure
A). After positioning of the panel, fix the panel onto the outer door by screws and bolts (See figure B).
Step 3. Tension adjustment of the door spring
1. The door springs are set at the factory to the proper tension for the outer door. If aesthetic panel are installed,
you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax
the steel cable.
2. Door spring tension is correct when the door remains horizontal in the fully opened
position, yet rises to a close with the slight lift of a finger.
Step 4. Dishwasher installation steps
Please refer to the specified installation steps in the installation drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation strip is flush with
edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into the cabinet.
6. LLevel the dishwasher. The rear foot can be adjusted from the front of the dishwasher by turning the Philips
screw in the middle of the base of dishwasher use a Philips screw driver. To adjust the front feet, use a flat screw
driver and turn the front feet until the dishwasher is level (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)
8. Adjust the tension of the door springs by using a Philips screw driver turning in a clockwise motion to tighten
the left and right door springs. Failure to do this could cause damage to your dishwasher. (Step 11)
9. The dishwasher must be secured in place. Fix the side with screws
55