General Information; Pump And Manufacturer Identification; C Purpose Of The Manual - Annovi Reverberi XJS Serie Manual De Uso E Instalación

Purpose of the manual
The manufacturer has provided this manual to provide the operating instructions and the criteria to be com-
plied with when installing, using and maintaining the pump identified by designation on the cover.
The manufacturer supplies the original instructions in Italian.
The manufacturer may supply the original instructions in other languages in response to statutory or com-
mercial requirements.
If the pump is sold, the seller must pass on this manual to the new owner along with the appliance.
The instructions are intended for the skilled, suitably trained operators who carry out the installation and rou-
tine maintenance procedures.
Refer to the table of contents for rapid access to the topics covered.
The manufacturer reserves the right to amend the manual without notice, unless the amendments refer to the
pump's level of safety.
The purchaser must ensure that the installation is designed in accordance with the instructions in this manual,
statutory requirements, and the relevant national and local regulations.
The technical instructions in this "Use and Installation Manual" are the property of the manufacturer and must
be treated as confidential.
There may be differences between the illustrations and the pump's actual conformation, but any such differ-
ences will not affect the clarity of the instructions. If in doubt, request the necessary explanations from the
manufacturer.
The symbols shown and described below are used to identify safety risks or important information.
Danger - Warning
Identifies information or procedures the failure to comply with which may constitute a serious threat to
health and safety.
Caution - Take Care
Identifies information or procedures the failure to comply with which may constitute a threat to health and
safety or cause damage.
Information
Identifies useful and important information or procedures which should be borne in mind.

Pump and manufacturer identification

Data plate
The data plate shown here, containing essential information for safe operation, is affixed to every pump.
A) Manufacturer's logo
B) Serial number barcode
C) Model
D) Maximum pressure (bar or psi)
E) Serial number
F) Lubricant specifications
G) Maximum rpm
H) Maximum delivery rate (l/min or U.S. gpm)
Manufacturer's name and address
Annovi Reverberi Spa
Via Martin Luther King, 3
41122 Modena (MO) - Italy
English

GENERAL INFORMATION

A
H
G
F
M2010_6_322-CV
19
1
B
C
D
E
Use and Installation