Troubleshooting - Montipower BRISTLE BLASTER AXIAL Manual Del Usuario

EN Operating instructions
10.2 Technical data: Pressure regulator
Specifications
Compressed air connection
Weight
11. Lubrication / Maintenance
If the tool is new, ensure that the compressed air motor is lubricated before use. If a
lubricator connected in series is not used, add a few drops of light oil to the compressed air
connection daily. Proper lubrication will ensure a longer tool service life.
12. Service information
1. All maintenance work on the tool must be carried out exclusively by trained and qualified
technical personnel or by the dealer from whom you purchased the tool. Repair or
maintenance by unqualified personnel could result in injury and/or damage to the tool.
2. Use only original spare parts when servicing this tool. The use of unauthorized parts or
failure to comply with the maintenance instructions will void the warranty and pose a risk of
personal injury.

13. Troubleshooting

Error
Belt not rotating
or rotating slowly
10
Value Unit
G 1/4"
90 g
Cause
Compressor not working
Filter or compressed air hose
clogged
Insufficient compressor
pressure
Insufficient compressor power
Compressed air hose too long
Compressed air hose diameter
too small
Compressed air motor not
sufficiently lubricated
Valve or valve sealing ring
defective
BRISTLE BLASTER
Solution
Switch on or check compressor
Clean compressed air line
Increase compressor pressure
Use stronger compressor
Use compressed air hose of
suitable length
Use compressed air hose of
suitable size
Add a few drops of oil to compressed
air connection
Service by qualified technician
®
AXIAL