Set The Time - Bauhn S1-BT Manual Del Usuario

Speaker Dock with Alarm Clock Radio
Power adaptor connection
•
Connect the AC adapter to the back of unit and plug into a wall outlet.
The LCD display turns on.
•
Remove the battery isolating tape from the battery compartment of the remote
conrol.
NOTE: 1 x 3V CR-2025 battery is pre-installled.
Adjust display brightness
•
You can adjust the brightness of the display backlight by pressing the "SNOOZE
I DIMMER" bar on top of the unit.
•
There are three different brightness settings: HIGH, MEDIUM or LOW.

Set the time

Press the "Time" button on the back of the radio.
1.
Select between 12-hour or 24-hour display by pressing the "+" or "-" button.
2.
Press the "Time" button again to adjust the hour by using the "+" or "-" button.
3.
Press the "Time" button a third time to adjust the minute by using the "+" or "-"
4.
button.
Press the "Time" button again to complete the time set process.
5
Set the radio
Press the power "ON/OFF" (
1.
®
The Bluetooth icon will appear on the display.
Press the "SET/MODE"(
2.
display.
Press and hold the "PLAY/PAUSE/SCAN" (
3.
The radio will automatically start to scan for available stations and store up to 20
stations accordingly.
Once the scan is completed, you can easily switch between the stations by
4.
pressing the "backward" (
NOTE: For best reception, fully extend the wire antenna. DO NOT strip, alter or
attach to other antennas.
10
serviceusa@tempo.org
All manuals and user guides at all-guides.com
) button on top of the unit.
) button twice until the "FM" icon is shown on the
) or "forward" (
) button for 2 seconds.
SCAN
) button.
AFTER SALES SUPPORT
USA
USA
Getting Started
866-235-5029