Bauhn S1-BT Manual Del Usuario página 13

USA
Instructions
You are now set to play music on the radio.
You can either use your device to control the the music or use the radio and/or
remote control.
NOTE: You may need to adjust the volume level on your device to achieve
proper volume.
The radio and your Bluetooth
off. When the radio is turned on again, it attempts to connect to the last connected
®
Bluetooth device automatically. If the last connected device is not available, the
radio attempts to connect to devices in memory one by one. The radio stays in
searching if there is no available paired device.
Connect to a non-Bluetooth
Use a 3.5mm audio cable (included) and plug it into the "AUX IN" audio line
1.
input located on the back of the unit.
Plug the other end of the audio cable into the line out or headphone jack of your
2.
audio device.
Press the power "ON/OFF" (
3.
Press the "SET/MODE"(
4.
display.
NOTE: For best reception, fully extend the wire antenna. DO NOT strip, alter or
attach to other antennas.
Sleep feature
While listening to a Bluetooth
button to activate the sleep timer.
This allows you to set a sleep timer for 90 to 10 minutes (in 10 minutes steps).
Once set, the unit will continue playing for the set length of time and will then
automatically turn off.
AFTER SALES SUPPORT
866-235-5029
USA
All manuals and user guides at all-guides.com
®
device store paired devices in memory when turned
audio device
®
) button on top of the unit.
) button until the "AUX" icon is shown on the
®
, radio or AUX source, press the "SLEEP" (
Speaker Dock with Alarm Clock Radio
serviceusa@tempo.org
)
SLEEP
13