Daikin FTXG20LV1BW Operación Manual página 34

Care and Cleaning
Titanium apatite photocatalytic air-purifying fi lter
1.
Take off the titanium
apatite photocatalytic air-
purifying fi lter.
• Open the upper front panel and pull out the air fi lters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
2.
Clean or replace the titanium
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
2-1 Vacuum dusts, and soak in
lukewarm water or water for about
10 to 15 minutes if dirt is heavy.
• Do not remove the fi lter from frame when
washing with water.
2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of polyester, do not
wring out the fi lter when removing water from it.
[Replacement]
Remove the fi lter from the fi lter
frame and attach a new one.
• Do not throw away the fi lter frame. Reuse the
fi lter frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
• When attaching the fi lter, check that the fi lter is
set in the tabs.
• Dispose of the old fi lter as non-fl ammable waste.
33
01_EN_3P357704-1.indd 33 01_EN_3P357704-1.indd 33
Tabs
3.
Set the fi lters as they were and
close the upper front panel.
• Return the panel support plate to its previous position.
• Lower the lower front panel to the original position.
• Close the upper front panel slowly.
• Press the upper front panel at both sides.
NOTE
• Operation with dirty fi lters:
– cannot deodorise the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odour.
• Dispose of old fi lters as non-fl ammable waste.
• To order titanium apatite photocatalytic air-purifying
fi lter, contact the service shop where you bought the air
conditioner.
Titanium apatite photocatalytic
Item
air-purifying fi lter (without frame) 1 set
Part No. KAF970A46
12/17/2013 3:22:25 PM 12/17/2013 3:22:25 PM