Mounting The E3200 Psa - Aimetis E3200 Serie Guía De Instalación Y Usuario

Step 7: Mounting the E3200 PSA
•
"(Optional) Position the E3200 PSA on a Shelf"
•
"(Optional) Wall Mount Instructions"
(Optional) Position the E3200 PSA on a Shelf
If the is positioned on a flat surface, install the 4 rubber feet included with the device.
E3200 PSA
• Screw the rubber feet into the 4 holes on the bottom of the device.
(Optional) Wall Mount Instructions
You can place the
E3200 PSA
sary.
The package includes a box with:
E3200 PSA
• 2 metal wall mounts
• 4 small screws with integrated spring washer and flat washer to hold the metal wall mounts to
the
E3200 PSA
• 4 screws and 4 plastic screw anchor/wall plugs appropriate for drywall or plaster. If you are
installing the
E3200 PSA
appropriate screws and anchors.
Required:
• Phillips screw driver
• Power drill
• Drill bit a little smaller than the closed end of the plastic anchor (or the same size for metal
anchors)
Attaching the Wall Mounts to the E3200 PSA
To attach the wall mounts to the E3200 PSA:
1. With the unit flat on a desk, turn it upside down so that the Aimetis logo is not visible.
2. Place the metal wall mount with the two-hole side, flush with the
3 holes and 2 large slotted holes will be used to attach the unit to the wall.)
All manuals and user guides at all-guides.com
flat on a shelf, but wall mounts are supplied for wall mounting, if neces-
onto a wood or concrete wall, you must supply your own material-
Figure 25: Position metal wall mount on bottom of E3200 PSA
25
. (The side with
E3200 PSA

Mounting the E3200 PSA