Battery Change - Onkyo RBX-500 Manual De Instrucciones

How to use Remote controller
Remove the insulation sheet before use.
When using the remote controller, point it toward the
remote control sensor, as shown below.
20°
30°
20°
Notes:
• If the light receiving area is exposed to strong light
such as direct sunlight or inverter fluorescent, the
remote controller may not work.
• If another infrared device is nearby or another
remote controller is used at the same time, the
remote controller may not work correctly.
Place for installation
Use in a place exposed to direct sunlight or a steriliza-
tion lamp may cause discoloration by influence of
ultraviolet rays.
To enjoy the 3D sound effect, it is recommended to
install the unit in a free and open area.
En-6
All manuals and user guides at all-guides.com
Insulation sheet
30°
Approx. 5 m
(16.4 ft.)

Battery change

In replacing the battery, ensure to use the specified
model.
1 With pushing the stopper in sideways,
pull out the battery holder.
Backside of
remote controller
Stopper
2 Place a lithium battery on the battery
holder, and return the holder into the
remote control until it clicks.
Plus (+) marking is
on the upper side
Notes:
• Specified battery model must be used; other-
wise you have a risk of a burst.
• A battery must be kept away from children. In
case a child swallows a battery, consult a physi-
cian immediately.
• Do not attempt to recharge, short-circuit, dis-
assemble, heat the battery, or put it in fire. It
may cause overheat, burst or fire.
• If you do not use the remote controller for a
long time, remove the battery from it to avoid
a damage caused by a fluid leak or corrosion.
Battery model